A tray for things that stand on edge. The walls have open slots every few millimetres, leaning back at the angle you choose, and the dividers sit in them on small tabs, so you can move or pull them out. Several columns are split by fixed walls.
The editor
The Divider Tray editor: settings on the left, the model updates as you change them.
All settings
- Material thickness - 3-6.5 mm
- Width - 60-600 mm
- Depth - 60-600 mm
- Height - 30-300 mm
- Columns - 1-6
- Slot spacing - 8-60 mm
- Divider lean - 0-30 °
- Dividers per column - 0-20
- Finger notch depth - 0-30 mm
- Finger density - 1-50
Cutting and assembly
You get a ZIP with a DXF and an SVG. Engraving is black, inner cuts are blue, outlines red and part names green, so LightBurn imports them as separate layers in the right order. Sizes are net - set the kerf in your laser software, not here. Assemble the floor and walls with the inner walls, then slide the dividers into the slots from above.